Installation Guide

31
Prohibited
WARNING
Cleaning the bathtub
Dirt gets harder to remove the longer it stays in
one place. Cleaning the tub after bathing while the
tub is still wet makes cleaning up
easy. To keep the tub fresh and
clean at all times, please be good
about cleaning. Apply a pH neutral
bathtub detergent with a sponge or
cloth, wash, rinse with water within 5
minutes and then wipe dry.
ӿ After cleaning the bathtub, please press the Purge button on the controller and purge the bathtub.
► See page 33.
Cleaning the suction
If hair or residue blocks the suction, the Hydro Hands / shoul-
der-warmer will have less force and won’t function fully. It
could also cause the pump to break down.
Please clean it at least once a week.
► See page 35.
► See page 37.
► See page 36.
Cleaning the air jet cap
Cleaning the pillow
Cleaning the controller
ӿ Dirt and debris on the
water outlet may cause dis-
order in the water fall.
Clean the water outlet using
the cleaning spatula pro-
vided for the shoulder-
warmer outlet to remove
foreign matter around it.
Cleaning the various parts
► See page 36.
Cleaning the lighting module
Cleaning the plated parts
To remove dirt and debris, please soak a
soft cloth in warm or cold water and wring it
well. When badly soiled, please use the
same cleaning methods as for the bathtub.
Cleaning the Hydro Hands / shoulder-warmer wa-
ter pipes
If the Hydro Hands / shoulder-warmer water has gone
without cleaning for a long time, flakes of dirt (residue)
deposited in the pipes may be released into the bath-
tub. To avoid the build-up of residue, the pipes should
be cleaned out about once a month using a commer-
cially available pipe cleanser.
Water outlet
Cleaning spatula for shoulder
-warmer water outlet
Do not remove the suction.
● Hands, feet or hair might become drawn in,
causing injury or drowning.
!
Care and cleaning
Cleaning