Installation Guide

7
Air jet cap
Jet
Precautions for use
Please follow these instructions regarding the NEOREST.
Do not allow an excess of water in the shower box.
● There is a drainage tray inside, but an overflow can
cause water leaks.
Be careful of the shower lid when it’s open.
● The corner of the lid can cause injury.
Use only genuine parts with this product.
● Otherwise, an unforeseen accident could result.
Keep the NEOREST neat and clean.
● If there is bath water residue, trace amounts of cop-
per ions in the water could react with the fatty acids in
the soap, causing a bluish tinge.
Clean out the suction filter carefully.
● This is to prevent pump damage.
Do not intentionally pour water over the controller.
● It is water resistant, but large amounts of water can
cause damage.
Do not cover the suction with a towel or wash-
cloth. Do not put things in the suction.
● This can cause damage to the equipment.
Do not block the air jet caps.
● Doing so could cause problems.
Do not apply pressure inside the jet or run water
through it.
● Water could get inside the air pump and break it.
Do not pour hot water over the controller or subject
it to impact.
● Doing so could break it.
Do not pour hot water over the suction or other
fittings or subject them to impact.
 Direct contact between the bathtub surface and
hot water in excess of 140°F (60°C) can damage
the surface.
 Dropping or striking the tub with makeup bottles
or other hard objects can cause scratches.
Do not use emulsive-type bath additives.
 While powder may remain inside the pump or
plumbing fittings, causing cloudy water to spray out
when using the air blower or Hydro Hands / shoul-
der-warmer.
 For other types of bath additives, please read the
instructions carefully and use them properly.
When using bath bubbles, do not run the air blower
or Hydro Hands / shoulder-warmer.
● Doing so will generate a large amount of bubbles and
the bubbles could remain in the pump or in the plumb-
ing fittings.
Introduction