Installation Guide

9
If a specific amount of time passes without any controller operations after all operations have stopped, then the
screen will go out by itself. Pressing a button (with no display) will turn the screen on and make operation possible.
There may be times when the display flashes or when there are streaks of color or brightness in the backlighting,
but these are not things that will affect the operation of the controller. Please be aware of that in advance. There
may be times when the controller will stop working in close proximity (around 50 cm) to an incandescent light or in
direct sunlight. Please adjust the angle of the controller stand or darken the surroundings before continuing.
Other
Turning off the display
The screen is lit and the control will work.
Buttons displaying a ■ or a □ indicate their operating mode or the fact that they are on or off.
Button status
OFF (□)
The backlighting looks blue.
ON (■)
When the lower four but-
tons are on, the back-
lighting looks orange.
There are three states. The left edge
(■) indicates the selected mode. The
display changes each time a button is
pressed.
■□□→□■□→□□■
The screen will be dark.
The backlighting will go dark after about 10
seconds, when nothing is running.
Turn the on/off button to off. Or
after around 30 minutes, if the
equipment has not been running or
if no buttons have been pressed.
Or after around 10 minutes, if the
equipment has not been running or
if no buttons have been pressed.
If any button is pressed.
(Any button at all)
Introduction