Installation Sheet

UNIFIT ROUGH-IN
INSTALLATION INSTRUCTION
Rev. 10/17
0GU185
PEOPLE-FIRST INNOVATION
™
P: 888-295-8134
F: 770-282-8701
MATERIALS REQUIRED:
1. Mounting bolts
2. Wax ring/seal
TOOLS NEEDED:
1. Tape measure
2. Screwdriver
3. Putty knife
4.
Power drill, ⁄”drill bit (for
woo d floor installation) & ⁄ ”
masonry drill bit
(for
masonry/tile floor installation)
- for mounting block
5. Pencil
PACKAGE CONTENTS:
1. Rough-In - 1
2. Mounting screw w/washer - 2
3. Anchor - 2
4. Installation template - 1
5. Installation instruction - 1
“RI”
12 inch
10 inch
14 inch
TSU08W.12
(supplied)
TSU08W.10
(optional - must be purchased separately)
TSU08W.14
(optional - must be purchased separately)
Rough-In Part Number
6 "
4"
8"
STEP 1 PIPING CHECK AND ROUGH-IN
1. In order for your new TOTO toilet to fit correctly, check the
dimensions in the Table below. Rough-In (“RI”): Distance between
finished wall to the center of the toilet outlet.
2. Remove existing toilet (if necessary)
Please make sure that you have the correct outlet connection part.
1155 Southern Road
Morrow, GA 30260
totousa.com |
STEP 2 INSTALLING MOUNTING BOLTS
1. Cover/block the drain opening to prevent items from falling into the drain and prevent smell from
coming up.
2. Clean any debris out of the closet flange.
3. Install the mounting bolts (either provided by the original closet flange or new wax ring) into the slots
of the flange. Insert the bolts into the slot with its head down and threaded shank pointed upward.
PAGE 1 of 2
Centerline of stop valve
Finished wall
4¾”
(120mm)
Centerline of ange
4¾”
(120mm)
3½” (90mm) M
AX
“RI”