Operation Manual

Page 93
English Español
Section
5
DROP FEED LEVER
Drop feed lever is in the
inside of shuttle cover. To
lower feed teeth, push the
lever forward, then to the left.
This position is used for but-
ton sewing, darning and
embroidery, For normal
sewing, push the lever to the
right, then release it.
FREE HAND EMBROIDERY
Drop feed teeth.
Set machine as shown.
Remove foot, and holder
screw.
To keep lower thread from
being pulled up, reduce upper
thread tension.
For good embroidery, it is
important to use the correct
needles and thread.
Use embroidery thread for
upper thread and a thinner
thread of same kind and color
for lower thread.
Trace your design on material
and center it in embroidery
hoop. Make sure material is
taut.
PALANCA PARA MOVER
LOS DIENTES
La palanca está en la parte
de adentro de la cubierta del can-
grejo, Para bajar los dientes de
arrastre, apretar al palanca hacia
adelante, despuès a la izquierda.
Esta posición se utiliza para el
pegado de botones, zurcido y
bordado. Para coser normal,
apretar la palanca a la derecha y
soltarla.
COSTURA PARA BORDAR
Preparar la máquina como se
indica, Quitar el pie prensatela y
el soporte con el tornillo.
Para evitar que se jale el hilo
inferior reducir la tensión del hilo
superior.
Para hacer un buen bordado es
importante usar las agujas e hilos
apropiados.
Usar hilo de seda en la parte
superior, y en la parte inferior
(carrete) uno más delgado del
mismo color.
Trazar el diseño sobre el material
y centrarlo en el bastidor.
Debe asegurarse que el material
esté estirado.
Needle
No. 9
No. 11
No. 14
Thread
120 ~100
100 ~ 80
60 ~ 50
Aguja
No. 9
No. 11
No. 14
Hilo
120 ~100
100 ~ 80
60 ~ 50
1
1