User manual

Connect the Hardware

Connect an Ethernet cable from

the modem to the WAN port on

your router.

If your Internet connection is through an Ethernet cable from the wall

instead of through a DSL / Cable / Satellite modem, connect the Ethernet

cable directly to the router’s WAN port, then follow steps 4 and 5 to

complete the hardware connection.

Modem

Power adapter

Router

Power adapter

7106506140 REV7.0.1

Turn off the modem and

remove the backup battery

if it has one.

Turn on the modem and

then wait about 2 minutes

for it to restart.

Internet

Quick Installation Guide

300Mbps Wireless N Router

Power

WLAN

WAN

Verify that the hardware

connection is correct by

checking these LEDs.

Note: If the WLAN LED is not on, please

press the WIFI ON/OFF button on the

back panel for 4 seconds and check the

LEDs again in a few seconds later.

WR841N / TL

WR841ND

Turn on the router.

PAGE 1
Quick Installation Guide 300Mbps Wireless N Router TL-WR841N / TL-WR841ND 7106506140 REV7.0.1 Connect the Hardware Power adapter Router If your Internet connection is through an Ethernet cable from the wall instead of through a DSL / Cable / Satellite modem, connect the Ethernet cable directly to the router’s WAN port, then follow steps 4 and 5 to complete the hardware connection. 4 Internet 1 Turn off the modem and remove the backup battery if it has one.
PAGE 2
Configure the Router 1. Connect your computer to the router (Wired or Wireless) C Either use the default or customize your wireless settings, and click Next. Note: If you change the default SSID and password, write down the new wireless settings. Wired Turn off Wi-Fi on your computer and connect the devices as shown below. Quick Setup - Wireless Wireless Network Name(SSID): POWER WAN 1 2 3 4 WPS/ RESET Disable Security WIFI ON/OFF WPA-PSK/WPA2-PSK Q3.