Manual

TracRac Inc. 994 Jefferson St. Fall River, MA 02721 l 800-501-1578

Instruction Manual

1.1 Upright Assembly

First take the upright (Item 4) and insert it into a 1.

modular saddle (Item 3).

Bolt the saddle through the top by using two 3/8”-16 2.

ﬂat head cap screws (Item 12) and tighten using

an 7/32” Allen Wrench (or 7/32” Allen Drive Bit).

Torque the 3/8” -16 FHCS to 32 ft-lbs. We recom-

mend threading both ﬂat head cap screw initially by

hand to ensure that you don’t cross thread the bolt.

1.1.1 When tightening the 3/8” ﬂat head cap screws

ensure that the allen key is fully seated in the bolt so

that it will not strip

Now take the upright and saddle and bolt it to the 3.

modular base (Item 5)

Bolt the base through the bottom by using two 4.

3/8”-16 ﬂat head cap screws (Item 12) and tighten

usingan 7/32” Allen Wrench (or 7/32” Allen Drive

Bit.) Torque the 3/8” -16 FHCS to 32 ft-lbs.

For the other front upright repeat steps one through 5.

four, except use (Item 6) in step three.

Repeat Steps 1-5 on each of the uprights6.

1.1.2 NOTE: Item 5 and Item 6 are mirror images of each

other. Reference the packing checklist to conﬁrm what

part to use.

Step 1

Part 1 - Uprights

Figure 1.1

Note:

Both

surfaces

must be

parallel

with each

other