Owner's Manual

PART 2 Electrical Connection

WARNING!

Ensure that the power supply is disconnected before proceeding. Verify that the power supply matches the ratings

found on the appliance data label before proceeding. The complete appliance must be properly grounded at all

times when electrical power is applied. Do not ground the appliance with the neutral (white) house supply wire. A

separate ground wire must be utilized. Failure to complete electrical connections properly may result in damaged

or non-functional systems. Follow instructions carefully to ensure proper installation.

It is the owner’s responsibility to ensure that a qualified person performs the electrical connection of this

appliance. The electrical installation, including minimum supply wire size, must comply with the National

Electric Code ANSI/NFPA 70-1990 (or latest revision) and local codes and ordinances. A copy of this

standard may be obtained from:

National Fire Protection Association, 1 Batterymarch Park, Quincy, Massachusetts 02169-7471

Important Electrical Requirements: Observe all National and local governing codes and ordinances. Have all

electrical installation done by a qualified electrical installer. This Liner requires a 120 Volt, 60 Hertz electrical

supply of an individual properly grounded branch circuit protected by a 15 or 20 Amp circuit breaker.

The TRADE-WIND

L7200 Series BBQ Liner is supplied with a 6.0 Amp three speed fan control.

For safety precautions, each Ventilation Liner should be installed in a GFCI protected branch circuit.

INSTRUCTIONS:

Wire connections: (See Diagram Below)

There are 3 wires on the front panel that require connection.

BLACK

120 VAC from electrical panel (usually black)

WHITE

Neutral from electrical panel (white)

GREEN

Ground from electrical panel (usually green)

CAUTION:

The neutral wire (white) must only be connected to the white neutral wire coming in from the electrical panel.

Hood

House Electrical

Panel

Green or bare wire

White

(N)

120V Black (L)