Owner's Manual

PART 3 Direction of Vent and Securing the Liner

MOUNTING HOLES:

Because the TRADE-WIND

L7200 Series BBQ Liner was designed for all applications, no mounting holes

have been pre-drilled. This allows for custom applications for mounting. The Liner should be attached to the

framing through the top and back, whenever possible. Remove the filters. Mark and drill screw holes through the

Liner as required. Secure the Liner by driving screws (provided by others) through the screw holes.

**NOTE: DRILLING THROUGH STAINLESS STEEL REQUIRES TITANIUM DRILL BITS. BE CAREFUL NOT TO

DRILL THROUGH THE UL LABEL OR INTO THE LINER’S ELECTRICAL COMPONENTS

PART 4 Use and Care

OPERATING CONTROLS:

Always activate the ventilator when using cooking appliances. Activate the ventilator a few minutes before starting

to cook to establish an airflow pattern within the room. Adjust the fan speed as needed. Adjust the dimmable

halogen lights as desired.

WARNING!

Do NOT operate the blower / ventilator system without the filters in place, or with dirty, grease laden filters.

ENERGY SAVING TIPS:

Do not operate the blower at a speed higher than necessary to remove the cooking exhaust. Turn off the unit once

the smoke and cooking odors have been eliminated. Clean filters and grease laden surfaces often to improve

efficiency.

CARE & CLEANING:

Proper cleaning is necessary to maintain performance and appearance, while also ensuring safe operation.

The frequency of cleaning should be adjusted according to the type and amount of cooking. Best results will be

achieved by cleaning soiled components as soon as possible. Filters must be cleaned regularly. Using the

aluminum knobs, lightly pull the filter toward the front of the liner while pulling the backside downwards. Replacing

the filter is just as easy as taking it out. For visual instructions on how to remove the filters visit our YouTube page

(https://www.youtube.com/channel/UCwVIbi_9hbuIATTYvz43oBA).

The filters may be cleaned by hand washing in hot water using a mild detergent solution, or by placing them in a

dishwasher. Locate holes on the sides of the filter. Put filter in dishwasher with holes facing up so detergent can

enter filters. Dry the filters completely before using again. Rinse and dry with a soft lint-free cloth. Always wipe

stainless steel surfaces with the grain. Never wipe across the grain. After cleaning, reinstall the filters carefully.

>>Most common scrubber type pads will scratch the hood.

CAUTION:

If a commercially available stainless steel cleaner is used, it is important to read the labels for chlorine compounds.

Chlorine is a corrosive substance, DO NOT USE. Follow polish manufacturer’s instructions.

HALOGEN LIGHT BULBS:

Hoods are designed for halogen light bulbs. They can be purchased at most home and/or grocery stores.

We endeavor to incorporate the best technology provided to our industry, in manufacturing the

TRADE-WIND

products, therefore we reserve the right to change models, mode of operation,

and specification without prior notice.