Installation Instructions

CAUTION – To reduce the risk of fire and electric shock, install this (range hood) only with

Remote Blower models rated maximum 6 amps.

CONTENTS:

Part 1 - Planning The Installation Part 2 - Securing The Liner

Part 3 - Use & Care Part 4 - Electrical Connection (Give copy of these 2 pages to electrician.)

PART 1 Planning the Installation

Trade-Wind

Designer Series Liners are designed for installation inside custom hood canopies. Proper installation

of the liner is directly related to the material from which the custom canopy is constructed. A qualified person must

complete the installation of this unit. Because of the large size and weight of this hood / liner, two installers are

recommended. Plan the installation so that all minimum clearances are met or exceeded. Dimensions shown

provide minimum clearances, unless otherwise specified. Important: You must provide structural framing and tight

backing in the areas in which you are securing the liner inside your custom canopy. Failure to do so could distort

and damage the liner and void the warranty.

WARNING! For maximum ventilation performance, the bottom of the hood or liner should be 30 - 36

inches (76.2 - 91.4 cm) above the cooking surface (minimum is 24”). This would typically result in the

bottom of the hood being 66 - 72 inches (167.6 - 182.9 cm) above the floor. These dimensions provide for

safe and efficient operation of the hood. Always observe local building codes.

Important Cut-out Information

Cabinet or hood cutouts should be at least

” larger than the following outside dimensions

Models Available (by Width)

Pic

CFM

”

Sones

Control

Blower

290

VSL4302RC

VSL4362RC

VSL4422RC

VSL4482RC

3-Speed

Internal Motor

Notes:

1. Center of electrical access is 7" from the front & 2

” from side of liner. Connection access is behind filters.

2. Vent is centered left to right. Damper is not included.

3. Length & width cutouts should be

” larger than above dimensions.