Installation Instructions

PART 4 Electrical Connection

IMPORTANT: Copy this page for your electrical installer.

WARNING! Ensure that the power supply is disconnected before proceeding. Verify that the power supply

matches the ratings found on the appliance data label before proceeding. The complete appliance must be

properly grounded at all times when electrical power is applied. Do not ground the appliance with the neutral

(white) house supply wire. A separate ground wire must be utilized. Failure to complete electrical connections

properly may result in damaged or non-functional systems. Follow instructions carefully to ensure proper

installation.

It is the owner’s responsibility to ensure that a qualified person performs the electrical connection of this

appliance. The electrical installation, including minimum supply wire size, must comply with the National

Electric Code ANSI/NFPA 70-1990 (or latest revision) and local codes and ordinances. A copy of this

standard may be obtained from:

National Fire Protection Association, 1 Batterymarch Park, Quincy, Massachusetts 02169-7471

INSTRUCTIONS: A 15 to 20 amp electrical service is recommended for proper electrical supply. Always

observe local building codes. Always use a dedicated circuit.

Wire connections: (See Diagram Below) There are 3 wires on the front panel that require connection.

BLACK

120 VAC from electrical panel (usually black)

WHITE

Neutral from electrical panel (white)

GREEN

Ground from electrical panel (usually green)

CAUTION: The neutral wire (white) must only be connected to the white neutral wire coming in from the electrical panel.

Wiring Diagram

Diagram 1: All Models with Factory Installed Internal Motor/Blower

Liner

House Electrical

Panel

Green

120V Black

White

(N)