Owner manual

OVERVIEW AND SET-UP
SET-UP:
The EG-1 Custom V2 is ready to play right out of the
gig bag.
USING HEADPHONES:
The built-in headphone amp powers headphones from
the 1/8” output on the jackplate. To activate the
headphone!amp, plug into the headphone or 1/4”
jack. To!cycle through different tones (Clean/Boost/
Overdrive/Distortion),!push down on the tone knob. !
Be sure to unplug all cables from your!guitar when
not in use to save battery life.
USING THE AUX-IN:
The EG-1’s electronics allow you to mix an auxiliary
signal!with the guitar’s signal through headphones or
an amp. Plug your mobile device into the 1/8” aux-in
jack and adjust the volume on your device to the
desired!level.
SET-UP