Installation Guide

TREE HUGGER

Installation

1 . Adhere enclosed protective tree cushion square to the

backside of the Tree Hugger® using the included

double-sided tape, see diagram for proper placement.

2. Confirm length of your support member and placement of

tree hugger on tree. See support member chart and

diagram for your correct length to match clear trunk height

placement on the tree for the Tree Hugger®.

3. Insert the support member into the Tree Hugger® support

member opening.

4. Position the Tree Huggers with support member attached

at the same height against the tree trunk.

5. Apply pressure from the top and bottom of the support

member to properly seat and secure each Tree Hugger®

against the trunk.

6. Install and insert into the Tree Hugger® band slots and

around the trunk the included adjustable metal bands and

tighten and secure firmly. (see diagram)

7. For added attachment screw in one screw through each

dimple in the Tree Hugger® into the support member.

(refer to dimple locations on diagram)

TREE HUGGER

(3)

ADJUSTABLE METAL BAND(2)

PROTECTIVE CUSHION SQUARE (3)

SUPPORT MEMBER CHART

Clear Trunk Member Length

3’- 0” 3’- 11”

4’- 0” 5’- 02”

5’- 0” 6’- 04”

6’- 0” 7’- 07”

Fixed TREE HUGGER

Adjustable Metal Band

Protective Cushion Square

Clear Trunk Height

BAND SLOT

DIMPLES

SUPPORT MEMBER OPENING

Adjustable TREE HUGGER