User`s guide

TEW-714TRU User’s Guide Troubleshooting
© Copyright 2013 TRENDnet. All rights reserved.
45
Troubleshoong
Situaon: I enterd hp://tew-714tru but I am not able to access the unit.
What should I do?
Soluon:
Please enter the default IP address (192.168.10.1) to login.
Proceed following steps:
1� Turn the TEW-714HRE’s power switch on.
2� Reset the device to factory default sengs by pushing the reset buon for
2 seconds�
3� Make sure you have a good wireless connecon to the default
SSID:TRENDnet714_2.4GHz_XXXX printed on device label.
4� Make sure your laptop/PC does not join to any domain
5� Open a browser and enter hp://tew-714tru (The leading hp:// has to
be entered to resolve the host name)
Situaon: How do I reset the device to factory default?
Soluon:
1� Use a pin such as a staple to press and hold the reset buon at the
boom of the TEW-714TRU for 2 seconds.
2� You can also reset from the management page.
Situaon: I enterd hp://192.168.10.1 but I am not able to access the unit.
What should I do?
Soluon:
1� Turn the TEW-714TRU’s switch on�
2� Reset the device to factory default sengs by pushing the reset buon for
2 seconds�
3� Make sure you have a good wireless connecon to the default
SSID:TRENDnet714_2.4GHz_XXXX printed on device label.
4� Make sure your computer has no other network connecons. For
example, disconnect your Ethernet cable.
5� Open a browser and enter hp://192.168.10.1
Situaon: How do I make sure my unit is connected to a router/AP?
Soluon:
The LED will turn solid green when the TEW-714TRU is successfully connected
to a router/AP
Situaon: How can I access the TEW-714TRU once it is setup?
Soluon:
You can use its host name (hp://tew-714tru) or IP address to access the
TEW-714tru. When setup in repeater mode, the TEW-714TRU will get an IP
address from your router (DHCP). Check the DHCP client list on your router if
you want to access the TEW-714TRU with its IP address�