User`s guide

TEW-714TRU User’s Guide FCC Interference Statement

Federal Communicaon Commission Interference Statement

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protecon against harmful interference in

a residenal installaon. This equipment generates uses and can radiate

radio frequency energy and, if not installed and used in accordance with

the instrucons, may cause harmful interference to radio communicaons.

However, there is no guarantee that interference will not occur in a parcular

installaon. If this equipment does cause harmful interference to radio or

television recepon, which can be determined by turning the equipment o

and on, the user is encouraged to try to correct the interference by one of the

following measures:

• Reorient or relocate the receiving antenna�

• Increase the separaon between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent from that

to which the receiver is connected�

• Consult the dealer or an experienced radio/TV technician for help.

FCC Cauon: Any changes or modicaons not expressly approved by the

party responsible for compliance could void the user’s authority to operate

this equipment.

This device complies with Part 15 of the FCC Rules. Operaon is subject to the

following two condions: (1) This device may not cause harmful interference,

and (2) this device must accept any interference received, including

interference that may cause undesired operaon.

IMPORTANT NOTE:

FCC Radiaon Exposure Statement:

This equipment complies with FCC radiaon exposure limits set forth for an

uncontrolled environment. This equipment should be installed and operated

with minimum distance 20cm between the radiator & your body�

This transmier must not be co-located or operang in conjuncon with any

other antenna or transmier.

The availability of some specic channels and/or operaonal frequency bands

are country dependent and are rmware programmed at the factory to match

the intended desnaon. The rmware seng is not accessible by the end

user�