User's Guide

TRENDnet User’s Guide

TWG-431BR

Virtual LANs (VLANs)

System> VLAN Setup

Your router supports 802.1Q tagged VLANs as well inter-VLAN routing. VLANs can be

assigned different IP address interfaces in which the router can route between VLAN IP

subnets. The router supports up to 7 802.1Q tagged VLANs.

Note: The default VLAN must be assigned as Native to access the router management

interface.

Enable an 802.1Q tagged VLAN

Your router supports 802.1Q VLAN tagging/trunking to other 802.1Q VLAN devices such

as managed switches.

1. Log into your router management page (see “Access your router management page”

on page 7).

2. Click on System and click VLAN Setup.

3. Under VLAN #2, click Network.

4. For the VLAN Mode, select Enable.

5. Under IP Setup, enter the IP Address and Subnet Mask for the new VLAN.

Ex: We will enter the interface IP address as 192.168.50.1 and subnet mask

255.255.255.0.

6. Under VLAN Tag Setup, enter the VLAN tag/VID of the new VLAN.

Ex: We will enter the tag/VID 50 for the new VLAN.

7. Click Save at the bottom. Then click Reboot at the top right to commit the changes.

Note: If using multiple WAN mode, under Specify WAN Port, you can select which WAN

to direct the outbound traffic for the VLAN.