User's Guide

TRENDnet User’s Guide

TWG-431BR

Dynamic routing protocols

Advanced > IP Routing Rule Setup

You may want set up your router to route computers or devices on your network to

other local networks through other routers. Generally, different networks can be

determined by the IP addressing assigned to those networks. Generally speaking and for

the case of an example, your network may have 192.168.10.x IP addressing and another

network may have 192.168.20.x IP addressing and because the IP addressing of these

two networks are different, they are separate networks. In order to communicate

between the two separate networks, static routing needs to be configured. Below is an

example diagram where routing is needed for devices and computers on your network

to access the other network. If you have other routing devices that support dynamic

routing protocol, you can enable these routing protocols on your router to learn and

automatically generate the routes needed between these networks.

Routing Information Protocol (RIP)

Advanced > IP Routing Setup / Advanced > IP Routing Rule Setup

Note: The RIP version is RIP version 2.

1. Log into your router management page (see “Access your router management page”

on page 7).

2. Click on Advanced and click on IP Routing Setup.

3. Review the RIP Routing section. To save changes to this section, click Apply to

command save your changes.

• Service: Check Enable to enable the RIP version 2 routing protocol.

• Distribute OSPF over RIP: If you are using both RIP and OSPF dynamic routing

protocols at the same time, this option will distribute OSPF routes over RIP

protocol to other RIP enabled devices.

Under RIP Side (Devices) Settings, select the interface you would like to enable the RIP

protocol.