User's Guide

TRENDnet User’s Guide

TWG-431BR

4. Click Save at the bottom. Then click Reboot at the top right to commit the changes.

5. Click on Advanced, click on IP Routing Rule Setup, and next to the first entry, and

click Edit.

6. Review the Routing section.

• Service: Select Enable to enable the route or disable to disable the route.

• Destination Net/Mask: Enter the IP network address of the destination network

for the route or network to distribute for the RIP/OSPF protocol (e.g.

192.168.150.0/24)

• Via

o Gateway: This option configures that static route to an external IP

network and specify the gateway IP address. If choosing this option,

enter the Gateway IP address. (e.g 192.168.10.2)

o Interface: This option configure an interface route. If choosing this

option, click the drop-down list and select the interface.

• Metric: Enter the metric or priority of the route. The metric range is 1-255, the

lowest number 1 being the highest priority.

• RIP – Selecting Enable will distribute the network route to other RIP enabled

devices.

• OSPF – Selecting Enable will distribute the network route to other OSPF enabled

devices.

You can check the current routing table Advanced > IP Routing Status.

6. Click Save at the bottom. Then click Reboot at the top right to commit the changes.