User's Guide

TRENDnet User’s Guide

TWG-431BR

Bandwidth Control

System > VLAN Setup > Bandwidth Control

1. Log into your router management page (see “Access your router management page”

on page 7).

2. Click on System, click on VLAN Setup, click on the drop-down arrow next to Network

and select Bandwidth Control.

Note: The bandwidth control setting is applied per VLAN interface. By default, VLAN1 is

considered as the LAN interface of the router.

3. Under the Bandwidth Control settings, review the settings below.

• Enable: Enables the bandwidth control feature for the VLAN.

Total Bandwidth Control

• Upload (Kbps): Enter the maximum upload bandwidth you would like to allocate

to the VLAN in kilobits per sec. It is important to set this value accurately.

Note: This should not be the total bandwidth allocated by your ISP but a portion

you would like to allocate only for the selected VLAN.

• Download (Kbps): Enter the maximum download bandwidth you would like to

allocate to the VLAN in kilobits per sec. It is important to set this value accurately.

Note: This should not be the total bandwidth allocated by your ISP but a portion

you would like to allocate only for the selected VLAN.

Note: If you are using multi-WAN mode, you can combine the total download

bandwidth of the WAN connections. Please note that performance throughput is

limited of up to 200Mbps per WAN connection in multi-WAN mode.

Bandwidth Rules

In the rules list, review the settings below.

The rules will allow you to create specific bandwidth control limits based on a specific

type of traffic or IP address or IP address range.

• Active – Enables the bandwidth control rule.

• Rule Mode – Click the drop-down list to select the specify the type of traffic

you would like to apply the bandwidth rule.

• Value 1/Value 2 – If selecting IP/Mask, IP Range Range, or Port, these fields will

allow you to enter the specific IP network, range or ports to apply the

bandwidth rule.

• Upload (Kbps) – Enter the maximum upload bandwidth to apply to the

specified traffic.

• Download (Kbps) – Enter the maximum download bandwidth to apply to the

specified traffic.

• Comment – Enter a description for the rule. (Optional)