User's Guide

© Copyright 2019 TRENDnet. All Rights Reserved.
57
TRENDnet User’s Guide
TWG-431BR
Setting up IPsec server VPN (PSK)
1. Log into your router management page (see “Access your router management page”
on page 7).
2. Click on System and click IPsec Server Setup.
3. Under IPsec List, click Create New IPsec.
4. For the Service, select Enable.
4. Click the Connection type drop-down list and select Remote Access (Roadwarrior).
5. Click the Mode drop-down list and select Client-to-LAN.
6. For the Local ID Type, select IP Address.
7. In the Local Subnets field, enter the local LAN IP subnet. (e.g. 192.168.100.0/24).
You can add additional local subnets if needed. (e.g. 192.168.10.0/24,192.168.120.0/24)
8. For the Remote ID Type, select IP Address.
9. Enter the Pre-Shared Key (PSK) for the IPsec VPN tunnel. (e.g. 1234567890)
10. Click Save at the bottom. Then click Reboot at the top right to commit the changes.
Note: For the VPN client computer, you will require a third party IPsec VPN software to
be installed configured matching the IPsec VPN settings on your router. Please refer to
your third party IPsec VPN User’s Guide/Manual for configuring the VPN settings.