Installation & Assembly

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Back Plate
Ball Nut (G)
Bulb Type A Max.100W
(not included)
Rubber Pad (H)
Parts:
Mounting Screw (B)
Green Grounding
Screw (C)
Lock Nut (F)
Wire Nut (E)
Cross Bar (A)
Ball Nut (G)
Metal Frame
Headless Screw (D)
Glass Shade (I)
Rubber Pad (H)
Photocell
IMPORTANT:
The sensor has an excellent photocell function
to enable the light to turn on at dusk and off at
dawn automatically.
Set Screw
Metal Ring
Glass Shade (I)
1. Thread two headless screws through the cross bar,
then secure them with four lock nuts (two on each
side of the cross bar). Adjust the length of the
headless screws if necessary.
Note: Make sure that the headless screws are lined
up horizontally, to ensure that the fixture will be level.
2. Attach the cross bar to the outlet box by using two mounting screws.
3. Take glass shade and gently slide it into the metal frame in place, then
attach the metal ring onto the metal frame by aligning holes, screw the set screws from the bottom
holes of the metal ring into the holes on the bottom of the metal frame.
Cross Bar (A)
House Grounding Wire
Green Grounding Screw (C)
Fixture Grounding Wire
Wire Nut (E)
Outlet Box
Fixture Wire
Mounting Screw (B)
Lock Nut (F)
Headless Screw (D)
WARNING: Turn off the main power at circuit breaker before installing fixture.
AVERTISSEMENT: Coupez la source d’alimentation principale au panneau
central de disjoncteurs avant d’installer le luminaire.