Installation & Assembly

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
House Grounding Wire
Green Grounding Screw (C)
Wire Nut (E)
Mounting Screw (B)
Headless Screw (D)
Outlet Box
Fixture Wire
Lock Nut (F)
Back Plate
Ball Nut (G)
Bulb Type A Max.100W
(not included)
Mounting Plate (A)
Rubber Pad (H)
Parts:
Mounting Screw (B)
Green Grounding
Screw (C)
Lock Nut (F)
Wire Nut (E)
Ball Nut (G)
Metal Frame
Headless Screw (D)
Glass Shade (I)
Rubber Pad (H)
Photocell
IMPORTANT:
The sensor has an excellent photocell function
to enable the light to turn on at dusk and off at
dawn automatically.
Set Screw
Metal Ring
Glass Shade (I)
1. Thread two headless screws through the mounting
plate, then secure them with four lock nuts (two on
each side of the mounting plate). Adjust the length
of the headless screws if necessary.
Note: Make sure that the headless screws are lined
up horizontally, to ensure that the fixture will be level.
2. Attach the mounting plate to the outlet box by using two mounting screws.
3. Take glass shade and gently slide it into the metal frame in place, then
attach the metal ring onto the metal frame by aligning holes, screw the set screws from the holes
of the metal ring into the holes on the bottom of the metal frame.
Fixture Grounding Wire
Mounting Plate (A)
WARNING: Turn off the main power at circuit breaker before installing fixture.
AVERTISSEMENT: Coupez la source d’alimentation principale au panneau
central de disjoncteurs avant d’installer le luminaire.