Assembly & Installation Instructions

Page 1 of 3

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. Read and save these instructions.

Important to Know

1. Read all instructions carefully before installation and operation.

2. If you are not familiar with state and local electrical codes, it is recommended that you consult with a qualified

electrician.

3. Before installation, shut off power at the main fuse or circuit breaker box. Be aware that simply turning off the

wall switch is not sufficient to prevent an electrical shock.

4. This fixture requires a 120 VAC, 60 Hz power source.

5. Do not attempt to take the lantern apart; there are no serviceable parts inside.

Maximum Wattage: 60W Incandescent Bulb

Work Temperature: - 4°F~104°F

Mounting Unit

Mounting Screw

Wire Connector

Finial

HARDWARE CONTENTS Note: Hardware not shown actual size.

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. Read and save these instructions. Important to Know 1. Read all instructions carefully before installation and operation. 2. If you are not familiar with state and local electrical codes, it is recommended that you consult with a qualified electrician.
PAGE 2
SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. WARNING ● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or switching off circuit breaker). ● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact any surface having a sharp edge.
PAGE 3
The following parts are available for re-order if damaged or missing. Spare Parts List: Mounting Unit X1 AA Wire Connector X3 CC Assembly Kit (1 SET) Mounting Screw X2 BB Finial X1 DD CARE AND MAINTENANCE ● To clean, turn off and wipe with a damp, non-abrasive cloth. TROUBLESHOOTING 1) The light does not come on at all: a) Make sure the wall switch and circuit breaker are on. b) Make sure the wiring is correct. 2) Fuse blows or circuit trips when light is turned on.