TRINITY DISHWASHER BK 110 User and installation instructions Contents Description Get to know your dishwasher How 1o run an ordinary dish washing programmer Table of programmed Unpacking, transit damage [detergent, rinse conditioner Loading the dishwasher Care and cleaning Safety Fault tracing, guarantee, service and spare parts Installation Page 822 29 66-00 Mod BK 10
GENERAL ADVICE ON THE DISH WASHING AND THE USE OF YOUR DISHWASHER; APPLICATIONS The dishwasher is designed for washing household utensils only. UNPACKING Inspect the product to ensure that it is undamaged. TRANSIT DAMAGE Damage sustained in transit must be reported within seven days to whoever is responsible for transportation. First read the instructions carefully. Then you will know how touche and look after your dishwasher in the right way. DESCRIPTION, see general illustration . Control panel .
Table of programmed net water temperature 15°C, 12 [EC settings. Total time could vary due to variation in inlet wale temperature.
Upper rack The upper rack is used far cups, saucers, glassware, bowls, tong knives, spatulas etc. Place cups and glassware in the rack upside down. Tilt deep dishes so that the water can drain off easily, The cup rack can be re positioned. Lower rack The lower rack is for heavier items like plates, large dishes, bowls, saucepans, casseroles, stc. Cutlery basket Spread the items in the cutlery basket so that the water can reach ali soiled surfaces. Make sure that spoons and forks are not nested.
CARE AND CLEANING Clean the exterior of the dishwasher using a liquid, non abrasive cleaner. The dishwasher has two spray arms and two filters, importation keep both spray arms and filters clean as dish washing efficiency will otherwise suffer. Spray arms Unscrew the round nut to remove the spray arms for cleaning. Clean the holes and flush or shake out any food remnants, etc. Screw the nut back in place.
SAFETY A switch in the door catch stops the machine if the door is opened. The dishwasher incorporates safety devices which close the water valve and start the discharge pump if too much water enters the machine. The main On/Off switch should always be in the "On” position to ensure operation of safety device. Problems? WHAT FAULT OCCURS Check the following points before calling a repairman.
INSTALLATION First a few words about official regulations: Electrical, water supply and drainage installation should be carried out by persons who are qualified and authorized to do such work. If you do any installation work yourself, find out about the relevant regulations and follow them carefully.
“(AlL 38) The dishwasher is designed for under counter installation but may also be used as a stand alone appliance. In such adventitious secured so that it cannot tip forwards when the door is opened end dishes, etc. are placed on it. The side {s} and fop pane should thee be fitted. IMPORTANT ‘The dishwasher must be perfectly feel in order to function satisfactory.
Water connection For connection to the water supply the making is fitted with a 1.5 m long inlet hose of polyethylene with a 3/4” threaded fitting at the free end. No extra non -return naive of suction trap is required. Thereat is an installation zones with a height of 176 mm and a depth of 80 mm for the hoses and outside pipes. Drain connections Water discharge: Note: the inside diameter of the hose must not be smaller than 13 mm.