Installation Guide

53
Note:
• To stop and exit the Start-Up Configuration, press and hold the Side
button for approximately 5 seconds. The Thermostat will apply default
settings as follows:
- HVAC type: HC (conventional system)
- Fan control option: HG (gas heating)
- Output test
•
The output terminals are tested in a predefined sequence to ensure the
safety of your HVAC equipment. As such, after you have tested a
specific output and proceeded to the next, you are not allowed to test
the previous output again. If you need to retest the previous output,
reenter the Start-Up Configuration as follows: Press and hold the Side
button for approximately 10 seconds. It will restart from Step 01.
Start-up Configuration
Ready to use
When you have completed the Start-Up
CongurationontheThermostat,the
Thermostat will enter Normal Operation and
you will see this display on the Thermostat.
Your Thermostat is now ready to use.
Note: If there is no input for more than one minute in Step 02 to Step 05,
the Thermostat will exit the Start-Up Conguration and return to Normal
Operation.