Owner Manual

8
Installation
Guide
Clearance
Door Height
Distance from
top of door to
mounting hole
Distance from
floor to track
mounting hole
1 1/2”
1/2”
+
+
=
5. Mounting a Single Door
Mounting
the T
rack t
o th
e
Wall
Follow these steps to mount the track for a
single door installation:
1. T
o locate the position of the first mounting hole on the track:
a. Mark where the closed position of the door will be and measure 1 1/8” in from this point.
b. Mark the location of the first mounting hole.
c. Calculate the distance from the floor to the track mounting holes. Mark the position for the
first mounting
hole.
Track Mounting Hole Calculation (from floor)
2. You can mount the track with, or without, Drywall Anti-crush Rings:
If you are mounting the track without Drywall Anti-crush Rings:
a. Pre-drill 1/8” diameter pilot hole for the first mounting hole.
b. Drill a 3/8” diameter hole for the first mounting bolt.
If you are mounting the track with Drywall Anti-crush Rings:
With proper blocking behind the drywall, you can mount the track(s) on top of the drywall or use
Drywall Anti-crush Rings. Note: The optional Anti-crush Rings come in 1/2” and 5/8” thickness.
Standoff Base
Bolt
Anti-crush
Ring
(optional, purchased
separately)
Track
Drill hole with 1-1/2”
spade/paddle bit
a. Use a 1 1/2” spade/paddle bit and drill a clean hole through the drywall until you reach the
blocking.
b. Insert the Drywall Anti-crush Ring (sold separately).
c. Pre-drill 1/8” diameter pilot hole for the first mounting hole.
d. Drill a 3/8” diameter hole for the first mounting bolt.