Owner Manual

11
Installation
Install the Anti-jump Disc
WARNING! Lack of, or improperly installed Anti-jump Disc may result in the door coming off the track
and cause serious injury or death. Installation of Anti-jump Disks are required for safe operation of this
hardware. Installed properly, these discs will keep the door securely attached to the track.
Follow these steps to install the Anti-jump Disc on all models:
1. Locate the screw for the Anti-jump Disc 3/8” of an inch in from the front edge of the door, between
the hanger and outside edge of the door.
2. Drill a pilot hole for the screw.
3. Place the Anti-jump Disc on the top of the door and screw in place.
4. Repeat steps 1 through 3 for the remaining hanger.
Installed Anti-jump Disc
Anti-jump
Disc
3/8”
Screw
(X4)
Apply Covers for Track (when not mounting multiple doors)