Manualshelf

Owner Manual

ManualsBrandsTrimlite ManualsBarn Interior DoorsPaneled Wood Unfinished Knotty Z-Bar Barn Door without Installation Hardware Kit
12345678910
5
Finished Wall
Important! The maximum door weight rating for attaching a door to head casings alone with no wall
blocking, is 75 lb. (see unfinished wall section for installing structural support for heavier doors). The
head casing must be a minimum of 1” thick and it is recommended it be a hardwood. We also
recommend that you paint or stain the head casing before attaching it to the wall.
1. Determine which direction you wish to open the door and open the door and follow directions
below accordingly.
2. Check the length of the rail(s). Cut the head casing to the desired length.
Note: The length of the head casing can be oversize if desired.
3. Using a stud-finder, find and lightly mark the location of the wall studs.
4. Place, and level, the head casing.
5. Securely fasten the head casing to the wall studs at the marked locations.
Head Casing
Finished Wall
Installation