Owner Manual

7
Installation
4. Assembling the Door
Important! The hardware is rated to handle a maximum door weight. Do not attach a door that exceeds
the weight capacity of the hardware. Maximum door Weight (lb) 220
Attaching the Hangers
Mount the holes drilled through the door. Use the following chart to select the correct drill bit
for the mounting holes:
Drill Instructions
Drill a 3/8” diameter clearance hole
Important! Hangers are mounted on the front (outside face) of the door. Follow these steps to attach the
hangers to the door:
1. Place the hanger (with 2 1/2” spacer set into groove of wheel) on top of the door.
Note: You can use stiff cardboard if needed.
2. Position the hanger the desired distance in from the outside edge of the door.
Note: Two inches is a recommended distance from the outside edge of the hanger and outside edge of
the door for all hangers.
3. Place a square against the hanger and square the hanger to the door.
4. Mark the hole positions.
5. Setup your power tool with the correct drill bit.
6. From the face to the door, drill a pilot hole through the face of the door.
7. Drill the clearance hole.
8. Place the hanger over the mounting holes and square it to the door.
9. Insert the correct hex bolts and washers from the back of the door.
10. Place the cap nut and washers on the bolt and securely fasten.
Attaching the Hanger
2
”