User Manual

15
Installation continued
1
Make sure that the VGA, audio* and RS-232 serial* source is
powered off.
2
(B130-101-2, B130-101A-2 and B130-101S-2 only) – Connect
the VGA and audio* source to the INPUT port(s) on the transmitter
unit using a VGA and audio* cable.
3
(B130-101S-2 only) – Connect the included 3.5 mm Male to DB9
Female adapter cable to the 3.5 mm INPUT port on the transmitter
unit, and then connect the computer to the adapter using a DB9 cable.
4
(B130-101-U only) – Connect the built-in VGA and USB connectors
on the transmitter unit to the source computer.
5
(B130-101-WP-1 and B130-101A-WP-2 only) – If you wish to
connect a local monitor and speakers*, connect the male end of the
included splitter cable to the INPUT port(s) on the transmitter unit,
and then connect one of the female ends of the splitter cable to
the source using VGA and audio* cable. If you are not connecting a
local monitor and speakers*, the source can be connected directly to
the INPUT port(s) on the transmitter unit without using the included
splitter cable.
6
(Optional) – Connect a local monitor and speakers* to the LOCAL
port(s) on the transmitter unit, or the remaining female connector(s)
on your splitter cable*, using a VGA and audio* cable.
Note: The B130-101S-2 comes with a local video port only, and does not
contain a local RS-232 Serial port.
7
Connect the external power supply to the transmitter unit, and then
plug it into a Tripp Lite Surge Suppressor, Power Distribution Unit
(PDU) or Uninterruptible Power Supply (UPS). The B130-101-U gets
power from the USB cable built-in to the transmitter unit and doesn’t
require external power supplies.
8
Using Cat5e/6 cable, connect the RJ45 OUTPUT port on the
transmitter unit to the RJ45 INPUT port on the receiver unit.
9
(B130-101-U only) – Connect the built-in VGA connector on the
receiver unit to the VGA port on a monitor.
*If this is a feature of your extender kit.
14-11-071-9333F9.indd 15 11/20/2014 4:42:45 PM