User Manual

16
Installation continued
10
Connect a monitor and speakers* to the OUTPUT ports on the
receiver unit using a VGA and audio* cable.
11
(B130-101S-2 only) – Connect the included 3.5 mm Male to DB9
Male adapter cable to the 3.5 mm OUTPUT port on the receiver unit,
and then connect the serial device to the adapter using a DB9 cable.
12
Connect the external power supply to the receiver unit, and then plug
it into a Tripp Lite Surge Suppressor, Power Distribution Unit (PDU)
or Uninterruptible Power Supply (UPS). The B130-101-U gets power
from the USB cable built-in to the transmitter unit and doesn’t require
external power supplies.
13
Turn on the power to the monitor, speakers* and RS-232 serial
device.*
14
Turn on the power to the monitor, audio* and RS-232 serial* source.
15
If necessary, adjust the equalization and gain controls using the
included screwdriver to improve the video image.
Note: The B130-101-U receiver unit contains a switch that changes the upper
and lower limits of the Gain adjustment control depending on the length of your
installation. If using 50 ft. or less of Cat5e/6 cable, this setting should be L.
If over 50 ft., it should be set to H.
*If this is a feature of your extender kit.
14-11-071-9333F9.indd 16 11/20/2014 4:42:45 PM