User Manual

20
1
Make sure that the VGA and audio* source is powered off.
2
Connect the VGA and audio* source to the INPUT port(s) on the
transmitter unit using a VGA and audio* cable.
3
Using the included daisy chain cable, connect the LOCAL port(s) on the
transmitter unit to the INPUT ports on a second-level transmitter unit.
Note: A standard VGA cable can be used to increase the distance between
units with no more than 6 ft. between.
4
Repeat step 3 for each additional transmitter unit you are adding to
the daisy chain, with no more than 6 transmitter units in the entire
installation.
5
(Optional) – Connect a local monitor and speakers* to the LOCAL
port(s) of the last transmitter unit in the daisy chain using a VGA and
audio cable.
6
Connect the external power supply to the first transmitter unit in the
installation, and then plug it into a Tripp Lite Surge Suppressor, Power
Distribution Unit (PDU) or Uninterruptible Power Supply (UPS).
7
Repeat step 6 for each additional transmitter unit in the installation.
8
Using Cat5e/6 cable, connect an available RJ45 OUTPUT port on the
transmitter unit to the RJ45 INPUT port on a receiver unit.
9
Repeat step 8 for each receiver unit you are connecting to the
installation.
10
Connect a monitor and speakers* to the OUTPUT ports on the
receiver unit using a VGA and audio* cable.
11
Repeat step 10 for each receiver unit in the installation.
12
Connect the external power supply to the receiver unit, and then plug
it into a Tripp Lite Surge Suppressor, Power Distribution Unit (PDU) or
Uninterruptible Power Supply (UPS).
13
Repeat step 12 for each receiver unit in the installation.
14
Turn on the power to the monitor and speakers.*
15
Turn on the power to the monitor and audio* source.
16
If necessary, adjust the equalization and gain controls using the
included screwdriver to improve the video image.
Installation continued
*If this is a feature of your extender kit.
14-11-071-9333F9.indd 20 11/20/2014 4:42:45 PM