User Manual

21
Installation continued
Extender/Repeater Kit Installation
(B130-101-2, B130-101A-2, B130-101-WP-1, B130-101A-WP-2,
B130-111 and B130-111A)
Note:
1. For models that support EDID copy, perform the EDID copy procedure described
in this manual prior to installation.
2. An extender/repeater kit installation can start with a B130-101-2,
B130-101A-2, B130-101-WP-1, B130-101A-WP-2, B130-111 or B130-111A.
The only difference between these kits is the type of remote unit that comes with
them. The B130-111 and B130-111A come with remote repeater units, while
the others come with remote receiver units.
3. The diagram above shows a B130-111A installation, with the maximum number
of remote units connected. Installation will be the same for the B130-111,
except there will be no audio connections. Installation will be the same for the
B130-101-2, B130-101A-2, B130-101-WP-1 and B130-101A-WP-2, except
that instead of adding remote units to the end of the installation, remote repeater
units will be inserted in between the local and remote units that come with the kits.
4. A 1024 x 768 (60 Hz) signal can be extended up to 1,000 ft. from the source to
the first remote repeater unit in the installation. A 1024 x 768 (60 Hz) signal can
be extended up to an additional 1,000 ft. between the first remote repeater unit
and the last display in the installation. Up to 4 remote units (3 remote repeaters
and 1 remote receiver) can be connected together to transmit a signal to
up to 4 points in a 2,000 ft. chain.
14-11-071-9333F9.indd 21 11/20/2014 4:42:46 PM