User Manual

Installation continued

5. To achieve maximum distance and performance, 24 AWG solid-wire Cat5e/6

cable must be used. The use of stranded wire Cat5e/6 cable, or cable with a

gauge (AWG) size higher than 24 AWG, will result in shorter extension distance.

All Tripp Lite N202-Series cables are made with 24 AWG solid-wire cabling.

Tripp Lite N022-01K-GY (Cat5e) and N222-01K-GY (Cat6) are 24 AWG solid-wire

bulk cables. For optimal image quality between 500 and 1,000 ft., use Zero-

Skew cable, such as Tripp Lite P524-01K.

6. To achieve maximum distance and performance, it is recommended that you use

Tripp Lite P502-Series VGA video or P504-Series VGA + audio cables with

RGB coax.

7. Test to make sure the entire installation works properly before pulling cables

through ceilings/walls.

Make sure that the VGA video and audio* source is powered off.

Connect the VGA video and audio* source to the INPUT port(s) on the

transmitter unit using a VGA and audio* cable.

(Optional) – Connect a local monitor and speakers* to the LOCAL

port(s) on the transmitter unit using a VGA video and audio* cable.

Connect the external power supply to the transmitter unit, and then

plug it into a Tripp Lite Surge Suppressor, Power Distribution Unit (PDU)

or Uninterruptible Power Supply (UPS). The Red power LED and the

Green RJ45 LED will illuminate to indicate the unit is receiving power.

Using Cat5e/6 cable, connect the RJ45 OUTPUT port on the

transmitter unit to the RJ45 INPUT port on a remote repeater unit.

Note: If you have a B130-101-2, B130-101A-2, B130-101-WP-1 or

B130-101A-WP-2 extender kit, you must add a remote repeater unit

(B132-110 or B132-110A) in between the transmitter and receiver units that

come with the kit. The B130-111 and B130-111A extender kits come with a

remote repeater unit.

Connect a monitor and speakers* to the OUTPUT port(s) on the

remote repeater unit using a VGA video and audio* cable.

Connect the external power supply to the remote repeater unit, and

then plug it into a Tripp Lite Surge Suppressor, Power Distribution Unit

(PDU) or Uninterruptible Power Supply (UPS). The Red power LED and

the Green RJ45 LED will illuminate to indicate the unit is receiving power.

*If this is a feature of your extender kit.

14-11-071-9333F9.indd 22 11/20/2014 4:42:46 PM