Manualshelf

User Manual

ManualsBrandsTripp Lite ManualsAccessories & SuppliesVGA over Cat5 / Cat6 Extender, Transmitter and Receiver with EDID Copy, 1920x1440 at 60Hz
21222324252627282930
23
Installation continued
If you are not connecting additional remote repeater units, proceed to
step 11 to complete the chain with a receiver unit.
8
Using Cat5e/6 cable, connect the RJ45 OUTPUT port on the first
remote repeater unit to the RJ45 INPUT port on a second remote
repeater unit.
9
On the remote repeater unit that you just added, connect a monitor
and speakers* to the OUTPUT port(s) using a VGA video and audio*
cable.
10
Connect the external power supply to the remote repeater unit, and
then plug it into a Tripp Lite Surge Suppressor, Power Distribution Unit
(PDU) or Uninterruptible Power Supply (UPS). The Red power LED and
the Green RJ45 LED will illuminate to indicate the unit is receiving power.
If you are not connecting additional remote repeater units, proceed to
step 11 to complete the chain with a receiver unit. If you are connecting
another remote repeater unit, repeat steps 8 through 10.
11
Using Cat5e/6 cable, connect the RJ45 OUTPUT port on the last
remote repeater unit to the RJ45 INPUT port on a receiver unit.
Note: If you have a B130-101-2, B130-101A-2, B130-101-WP-1 or
B130-101A-WP-2 extender kit, you will use the included receiver unit. The
B130-111 and B130-111A extender kits require a receiver unit to be
purchased separately.
12
Connect a monitor and speakers* to the OUTPUT port(s) on the
receiver unit using a VGA video and audio* cable.
13
Connect the external power supply to the receiver unit, and then plug
it into a Tripp Lite Surge Suppressor, Power Distribution Unit (PDU) or
Uninterruptible Power Supply (UPS).
14
Turn on the power to the connected monitors and speakers*.
15
Turn on the power to the VGA video and audio* source. The Orange
RJ45 LEDs will illuminate to indicate that the units are receiving a
signal from the source.
16
If necessary, use the included screwdriver to adjust the Equalization
and Gain settings on the remote repeater and receiver units to
improve the video image.
*If this is a feature of your extender kit.
14-11-071-9333F9.indd 23 11/20/2014 4:42:46 PM