User Manual

29
Installation continued
5
Connect the external power supply to the first transmitter unit in the
installation, and then plug it into a Tripp Lite Surge Suppressor, Power
Distribution Unit (PDU) or Uninterruptible Power Supply (UPS). The
Red power LED and the Green RJ45 LED will illuminate to indicate the
unit is receiving power.
Repeat step 5 for each transmitter unit in the installation. When power
has been connected to all of the transmitter units, proceed to step 6.
6
Using Cat5e/6 cable, connect an available RJ45 OUTPUT port on a
transmitter unit to the RJ45 INPUT port on a remote repeater unit.
7
Connect a monitor and speakers* to the OUTPUT port(s) on the
remote repeater unit using a VGA video and audio* cable.
8
Connect the external power supply to the remote repeater unit, and
then plug it into a Tripp Lite Surge Suppressor, Power Distribution Unit
(PDU) or Uninterruptible Power Supply (UPS). The Red power LED and
the Green RJ45 LED will illuminate to indicate the unit is receiving
power.
If you are not connecting additional remote repeater units, proceed to
step 12 to complete the chain with a receiver unit.
9
Using Cat5e/6 cable, connect the RJ45 OUTPUT port on the first
remote repeater unit to the RJ45 INPUT port on a second remote
repeater unit.
10
On the remote repeater unit that you just added, connect a monitor
and speakers* to the OUTPUT port(s) using a VGA video and audio*
cable.
11
Connect the external power supply to the remote repeater unit, and
then plug it into a Tripp Lite Surge Suppressor, Power Distribution Unit
(PDU) or Uninterruptible Power Supply (UPS). The Red power LED and
the Green RJ45 LED will illuminate to indicate the unit is receiving
power.
If you are not connecting additional remote repeater units, proceed to
step 12 to complete the chain with a receiver unit. If you are connecting
another remote repeater unit, repeat steps 9 through 11.
*If this is a feature of your extender kit.
14-11-071-9333F9.indd 29 11/20/2014 4:42:47 PM