Manualshelf

User Manual

ManualsBrandsTripp Lite ManualsAccessories & SuppliesVGA over Cat5 / Cat6 Extender, Transmitter and Receiver with EDID Copy, 1920x1440 at 60Hz
21222324252627282930
30
Installation continued
12
Using Cat5e/6 cable, connect the RJ45 OUTPUT port on the last
remote repeater unit to the RJ45 INPUT port on a receiver unit.
13
Connect a monitor and speakers* to the OUTPUT port(s) on the
receiver unit using a VGA video and audio* cable.
14
Connect the external power supply to the receiver unit, and then plug
it into a Tripp Lite Surge Suppressor, Power Distribution Unit (PDU) or
Uninterruptible Power Supply (UPS).
Repeat steps 6 through 14 for each additional RJ45 OUTPUT port on
each of the transmitter units, and then proceed to step 15.
15
Turn on the power to the connected monitors and speakers*.
16
Turn on the power to the VGA video and audio* source. The Orange
RJ45 LEDs will illuminate to indicate that the units are receiving a
signal from the source.
17
If necessary, use the included screwdriver to adjust the Equalization
and Gain settings on the remote repeater and receiver units to
improve the video image.
*If this is a feature of your extender kit.
14-11-071-9333F9.indd 30 11/20/2014 4:42:47 PM