Owners manual

6. Enclosure Configuration

6.1 Door Locks

6.2 Cable Access and Management

The front and back doors have locks that are accessible by the included keys.

Note: Model CS16USB does not contain a locking back door.

Each side panel locks using an L-shaped lever on the inside of the enclosure.

To unlock and remove the side panels, lift the shorter leg of the “L” up and pull it away from the

side panel. Pull the tab on the side panel and remove it from the enclosure.

To re-lock the side panels, secure it in the proper position, lift the shorter leg of the “L” up and

push it toward the side panel, back into the hole that it was in initially. Once it is in place, push

the shorter leg of the “L” down to lock it.

Note: To lock and unlock the side panels, you will need to have access to the interior of the enclosure.

To connect the tablet charge and sync station to a power outlet, run the power cord through the top

or bottom cable access plate containing a cord grommet by unlocking the front door and removing

one or both of the side panels (as shown in section 6.1)

. Then push the input plug through the

top or bottom cord grommet

and run the cord to your nearest 3-prong, grounded wall outlet

CS32USB