Operation Manual

underground, which is not insensitive for wet surroundings like a

television, HIFI or a bench.

• Take the water tank from the base, open the water lid by turning it

anticlockwise, fill in water, make sure that the silicon washer is well

fitted in its place and then close the water lid by turning it clockwise.

• Connect to power supply and turn on the switch. Setting proper mist

intensity by turning the mist intensity controller.

• Make sure that sprayer will be fixed to the middle of the room, without any

obstruction.

6. Cleaning and maintenance

• Water tank

• The water tank should be cleaned frequently. It is

recommended to clean once every 3 days.

• Water should be changed frequently. It should not be kept in

the water tank more than 2 days.

• Transducer

Due to geographic factors, water quality may differ from place to place. Some places

have hard water, which contains a large quantity of calcium and magnesium ions.

Furthermore, the use of bleaching power (to purify water) also increases the

hardness of water. When this kind of water is used to humidify the air, calcium and

magnesium ions are diffused together with the mist. As time goes on, there will be

sediments of scale on the object surfaces and ground. Meanwhile, there will also be

sediments on the transducer and the water groove, which is to affect the functioning

of the humidifier. To clean the transducer, please;

• Add some cleanser (about 0.5g) on the transducer, add some

water, and wait for 2-5 minutes.

• Use a soft brush to clean the surface of the transducer. Don’t

use hard tools to scratch its surface.

• Use cleanser, which you can buy in a market, for cleaning this

kind of plastic appliances.

• Do not use soap or other alkaline substances to clean the

transducer.

• Do not put this humidifier or some parts into the dish washer.

• Base

• If the water groove and water level detector have scale

sediments too, please use the cleanser to clean, and then

wash the water groove with clean water.

• Do not immerse the base in water and make sure that no water