Operation Manual
8
• Twist both ends of the exhaust hose into the square xing clip and the
at xing clip.
• Insert the square xing clip into openings at back of the air conditioner.
• Put the other end of the exhaust hose to the near windowsill.
Window Slider Kit Installation
• The installation manner of window slider kit is mostly in “horizontal”
and “vertical”, No much dierence in actual process.
CLEANING MAINTENANCE
• Before cleaning, be sure to disconnect the unit from any electric supply
outlet.
• First clean the surface with a neutral detergent and wet cloth, and then
wipe it with a dry cloth.
• Do not use gasoline or other chemicals to clean the unit.
• Do not wash the unit directly.
• If the conditioner is damaged, please contact the dealer or repair shop.
Air Filter
• If the air lter becomes clogged with dust/dirt, the air lter should be
cleaned once every two weeks.
• Open the air inlet grille and take o air lter.
• Clean the air lter with neural detergent in lukewarm(40°C(and dry it
up in the shade.
• Putting the air lter into the inlet grille, replace the components as
they were.
TROUBLE SHOOTING
Troubles Possible Causes Suggested Remedies
The unit does not start
when pressing power
button
• Water full indicator lamp blinks,
and water tank is full.
• Room temperature is higher
than the setting temperature.
(Electric heating mode)
• Room temperature is lower
than the setting temperature.
(Cooling mode)
• Dump the water out of the
water tank.
• Reset the temperature
• Reset the temperature
The unit doesn’t cool
enough
• The doors or windows are
not closed.
• There are heat sources inside
the room.
• Exhaust air hose is not
connected or blocked.
• Temperature setting is too high.
• Air inlet is blocked.
• Make sure all the windows
and doors are closed.
• Remove the heat sources if
possible
• Connect or clean the exhaust
air hose.
• Reset the temperature
• Clean the air inlet.
Instruction manual