Operation Manual

4
Instruction Manual
SAFETY INSTRUCTIONS
1. READ INSTRUCTIONS - All the safety and operating instructions should be read
before the appliance is operated.
2. RETAIN INSTRUCTIONS - The safety and operating instruction should be retained
for future reference.
3. HEED WARNINGS - All warnings on the appliance and in the operating
instructions should be adhered to.
4. FOLLOW INSTRUCTIONS - All operating instructions should be followed.
5. WATER AND MOISTURE - The appliance should not be used near water, for
example, near a bathtub, washbowl, kitchen sink, laundrytub, swimming pool or
in a wet basement.
6. VENTILATION - The appliance should be situated so that its location or position
does not interfere with its proper ventilation. Do not place on bed, sofa, rug or
similar surface that may block the ventilation openings, in a built-in installation,
such as a bookcase or cabinet that may impede the flow of air through the
ventilation openings.
7. HEAT - The appliance should be situated away from heat sources such as
radiators, stoves, or other appliances (including amplifiers) that produce heat.
8. POWER SOURCE - The appliance should be connected to power supply only of
the type described in the operating instructions or as marked on the appliance.
9. POWER CORD PROTECTION - Power supply cords should be routed so that they
are not likely to be walked on or pinched by items placed upon or against them.
10. POWER LINES - An outdoor antenna should be located away from power lines.
11. OBJECT and LIQUID ENTRY - Care should be taken so that objects do not fall and
liquids are not spilled into the enclosure through openings.
12. ESD WARNING - The display does not function properly or no reaction to
operation of any the control may due to the electrostatic discharge. Switch off
and unplug the set. Reconnect after a few seconds.
13. DAMAGE REQUIRING SERVICE - The appliance should be serviced by qualified
service personnel when:
a. The power-supply cord or plug has been damaged.
b. Objects have fallen into, or liquid has been spilled into the appliance enclosure.
c. The appliance has been exposed to rain.
d. The appliance has been dropped, or the enclosure damaged.
e. The appliance does not appear to operate normally.
14. SERVICING - The user should not attempt to service the appliance beyond that
described in the user operating instructions. All other servicing should be referred
to qualified service personnel.
Notes:
a. Dirty or scratched CD may cause a skipping problem. Clean or replace the CD.
b. If an error display or malfunction occurs, disconncet the AC cord and remove all
the batteries. Then turn the power back on.
BEFORE OPERATION
Notes: CONCERNING COMPACT DISCS.
Since dirty, damaged or warped discs may damage the appliance, care should be
taken of the followings items:
a. Usable compact discs. Use only compact disc with the mark shown below.
b. CD compact disc only with digital audio signals.
POWER SOURCES
AC POWER
You can power your portable system by plugging the detachable AC power cord into
the AC inlet at the back of the unit and into a wall AC power outlet. Check that the
rated voltage of your appliance matches your local voltage. Make sure that the AC
power cord is fully inserted into the appliance.