Instruction manual

Installation of Accessories
Install the long spray nozzle (12) or extended connecting spray nozzle (13)
Hold the pipe section of the long spray nozzle in your hand, align the arrow with the single-line mark on
short spray nozzle (2) on the machine body, and insert the long spray nozzle in position. Rotate the long
spray nozzle in clockwise direction, and align the arrow on the long spray nozzle with the double-line mark
on short spray nozzle on the machine body, as shown in figure (I). To remove the long spray nozzle, please
rotate the long spray nozzle inversely (counter clockwise) as shown in figure (II), and align the arrow on the
spray nozzle with the single-line mark on the machine body. Then the long spray nozzle can be pulled out.
For the extended connecting spray nozzle (13) you have to use the same procedure as shown above.
(I) (II)
Install spray with round brush (10) or bent spray nozzle(11)
For direct installation on short spray nozzle (2), aim the spray nozzle with round brush or bent spray nozzle
at the top of spray nozzle, as shown in figure (III), and push the spray nozzle upwards until it is in position.
(III)
Installation of spray nozzle for door/window (14 & 15)
First install the general spray nozzle (14) on short spray nozzle (2), as shown in figure (IV) Install the two
small hooks of the spray nozzle for door/window (15) onto suspension lugs of the general spray nozzle, and
then trigger the big hook of the spray nozzle for door/window, and push the spray nozzle for door/window
up and clutch (V) it onto the body of the general spray nozzle.
(IV) (V)