Item# 45-6808GR 84" Air Powered Hockey Please keep this instruction manual for future reference If you have any problems with your new product, please visit our website www.triumphsportsusa.com for the fastest expedited service possible for your replacement part ordering needs. Please have a copy of your receipt of purchase. For any technical support or warranty issues, please contact Triumph Sports USA at 1-866-815-4173 or email us at csr@triumphsportsusa.
Limited 90-Day Triumph Sports USA, Inc. Warranty All Triumph Sports USA, Inc. (TSU) games have a limited 90-day from date of purchase warranty. This warrants the retail purchaser for any TSU game purchased to be free from any defect in materials and construction for 90 days from the date of purchase. The only exceptions to the warranty include main frames, tabletops, playing surfaces, batteries or tools.
IMPORTANT SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS 1. 2. 3. 4. 5. 6. 7. 8. 9. Read all instructions-All the safety and operating instructions should be read carefully before the hockey game is played. Caution-This is not a toy and is intended for use by or under the supervision of adults. Adults should review safety guidelines with children to avoid possible risk of electric shock or other injuries. Power sources-This hockey game should be operated only from 110-120V A.C.
Parts List 1 2 MAIN CABINET 1 PIECE 8 FELT PAD 2 PIECES PUCK 2 PIECES 12 11 PRE-INSTALLED 13 17 PRE-INSTALLED 9 PRE-INSTALLED PRE-INSTALLED PUSHER 2 PIECES 10 3 x 20MM WASHER HEAD SCREW 12 PIECES ALLEN KEY 1 PIECE 14 PRE-INSTALLED 15 SIDE APRON 2 PIECES BLOWER 1 PIECE 18 5 LEG PANEL 2 PIECES LEG LEVELER 4 PIECES 5/16” WASHER 12 PIECES 5/16” x 1-1/4” BOLT 12 PIECES 4 RIGHT LEG 2 PIECES LEFT LEG 2 PIECES 7 6 16 3 19 PRE-INSTALLED PRE-INSTALLED END APRON-A 1 PIECE 20 P
Assembly Tips: Attention: If you are using an electric screwdriver in the assembly, please set at low torque and do not over tighten the hardware. When assembling individual parts, loosely tighten screws until all screws are inserted, then tighten completely Assembly Instructions 1. Find a clean, level place to begin the assembly of your Air Hockey table. The table will be assembled upside down and then turned over on its legs once the assembly completed.
FIG.2 INSTALL BATTERY 6. Lift the table assembly from the floor with at least two strong adults, turn it over, and set the table assembly on its legs in the location where you play. CAUTION: Two strong adults are recommended to turn the table over as shown. 1. Lift the table off the ground. 2. Turn the table over. 3. Place it on all four feet at the same time on the ground. HOLD TABLE CABINET DO NOT HOLD THE LEGS DO NOT LEAN THE TABLE ON ITS LEGS! 20 28 21 16 14 18 17 FIG.3 PUSHER ASSEMBLY 10.
FIG.4 INSTALL BATTERY 11. Under the table, Unscrew Bolt using a screwdriver and open the battery box, Insert 4 AA batteries (not included) in the order of polarity as shown on the inside of battery box, Then close using a screwdriver, Turn on the power by turn the on/off switch of battery box. (If the game will not be used for a long period of the time, we recommend that the batteries be removed.) FIG.5 B A C ON/OFF SWITCH -. Insert 4 AA Batteries (Batteries not included). - Unscrew and remove cover.
24 22 17 27 25 26 23 FCC IDENTIFIER Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.