Installation Guide

WARNING: blades should be at least 10 feet from floor
O
F
F
O
F
F
O
F
F
Turn off power at breaker
box to avoid possible
electrical shock.
Use metal outlet box suitable
for fan support.
Outlet box must support 35 lbs min.
Note 1: Note 2:
1. HANGING SYSTEM INSTALLATION
1A. Installing mounting bracket to ceiling outlet box
Install mounting bracket to outlet box in ceiling by using screws included with the
outlet box and washers from the hardware bag.
Outlet Box
Mounting
Bracket
1B. Installing Downrod and Yoke
Remove cross pin and cotter pin from downrod.
Loosen 2 downrod jam screws at yoke.
Insert yoke cover, deco ring, and canopy onto downrod.
Cross Pin
Cotter Pin
1
2
3
Downrod
1
1
Fan Assembly
2 Downrod Jam
Screws (2)
(Loosening)
Wires
Canopy
Yoke cover
3
Feed motor lead wires through downrod.
Insert downrod assembly into yoke and insert the cross pin through yoke & downrod, secure with cotter pin.
Tighten both downrod jam screws to secure downrod.
Pull down the yoke cover to cover yoke.
4
5
6
7
Wires
Yoke
4
Downrod
Assembly
Y
o
ke c
o
ver
Yoke cover
Downrod Jam
Screws (2)
(Tightening)
Canopy
7
Fan Assembly
6
Cotter Pin
5
Cross Pin
5
P3