Owner’s Manual proposal Tristan 11 3JUD18-3M This instruction contains 8 pages: Page 1: Read Safety instructions Page 2: Unpack and inspect parts contained Page 3~4: Notes before installation and Hanging system installation { Wire connection Page 5: Canopy installation / Blade installation / Bottom plate installation Page 6: Operational instruction / Remote Pairing Process Page 7~8: Remote Pairing Process Net weight S 17.0KGS. 374 LBS.
READ AND SAVE THESE INSTRUCTIONS WARNING : TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO PERSONS, PLEASE OBSERVE THE FOLLOWING : 1]. To ensure the success of the installation, be sure to read the instructions and review the diagrams thoroughly before beginning. 2]. To avoid possible electric shock, be sure electricity is turned off at the main power box before wiring. All electrical connections must be made in accordance with local codes, ordinances and/or the National Electric Code.
Unpack and inspect fan carefully to be certain all contents are included.
WARNING: blades should be at least 7 feet from floor Note 1: Note 2: Turn off power at breaker Use metal outlet box suitable for fan support. box to avoid possible Outlet box must support 35 Ibs min. electrical shock. (= 1. HANGING SYSTEM INSTALLATION 1A. Installing mounting bracket to ceiling outlet box Install mounting bracket to outlet box in sailing by using screws included with the outlet box and washers from the hardware bag. Outlet Box: Mounting —pc Bracket 1B.
2. WIRE CONNECTION 2A. Attaching safety cable to ceiling joist Use wood screw, spring washer, and flat washer from hardware bag. Pass wood screw through closed Ioo%of safety cable. Secure wood screw to ceiling slot on mounting bracket. Make sure cable has been tightened securely. CACTI! THE W CREW AND TS SUPPORT MUST BEADLE TO FULLY SUPPORT THE WEIGHT OF AT LEAST 100 LBS. ‘Safety,cable l Flat Washer [ outset ] % \ Spring Washer Wood Screw Safety cable 1 Mounting Bracket 2B.
3. CANOPY INSTALLATION Note: Two screws are per-installed on mounting bracket for canopy installation. (D) Push up canopy until twe screws per-screwed on mounting bracket are engaged with two key holes on canopy. (2)Rotate canopy slightly until two per-installed screw heads are engaged in the narrow end of key holes. (3) Tighten both screws. 4. BLADE INSTALLATION Attach blade assembly to spindle. Thread the nut counter-clockwise onto spindle.
6. PREPARE REMOTE TRANSMITTER @Remove battery cover. @ slide transmitter code switches to desired combination. (3 Slide code switch for light ON/OFF (marked as X), or DIMMING (marked as D) function. The optional Light Kit uses a Dilemma LED array so the code switch for light should be set at the D position unless only ON/OFF operation is desired. @ Install 9V DC install battery cover on transmitter. LOW:Fan low spade D: for light dimming MED:Fan midden sped Hi:Fan high speed.
-2. PAIRING PROCESS FOR MULTIPLE FANS 8-2. Paling Process for Multiple fans (One transmitter for multiple receivers) If you wish to use only one transmitter for two fans, simply wire up both fans at one time and perform the Pairing Process at step 8-1 from a point between the two fans. 8-2. Paling Process for Multiple fans (One transmitter for one receiver) The Pairing Process must be performed on each remote set (transmitter and receiver) individually. Each Codes of Transmitter must be different.
8-4. TO SET UP REMOTE FOR #2 FAN Make sure to turn off power at breaker Disconnecting wire from #1 Fan Disconnect the Black wires from #1 Fans and connect the Black wires back to #2 Fan that you remove from 8-3. Turn on power at breaker box and #2 Fan is ready forgetting? @H‘ *See the remote control setting process for 8-1 to set up #2 Fan. 8-5.