Operation Manual

EN 4
Operating manual – pedestal fan TVE 15 S / TVE 17 S
Assembly and start-up
Scope of delivery
1x Device TVE 15 S / TVE 17 S
1x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Mounting the foot
1. Assemble the two base elements of the foot(7).
7
2. Position the stand centrally on top of the two connected
base elements.
3. Use the supplied screws to connect the stand(4) to the
base elements. Screw the screws into the prepared bore
holes.
4. Push the stand's protective cap(8) onto the screwed
connection.
8
Connecting the operating element and pillar
Connect the control panel(2) and the pillar(4) and fasten the
connection screw(9) at the rear of the control panel.
2
4
9
Mounting the rotor
Fit the rear part of the protective grid(11) on the motor
spindle(10). Fasten both elements with the retaining ring(12).
10
11
12