Use and Care Manual

Not for

Reproduction

16 troybilt.com

Control Panel

A - 120 Volt AC, 20 Amp, GFCI Duplex Receptacles

— May be used to supply electrical power for the

operation of 120 Volt AC, 20 Amp, single phase,

60 Hz electrical, lighting, appliance, tool and motor

loads.

B - On/Off Switch — Set this switch to ON (I) before

starting engine. Set switch to OFF (0) to shut off

engine.

C - Battery Float Charger Jack — Use battery float

charger jack to keep the starting battery charged

and ready for use.

D - Display Button — Push to scroll through LCD

screens on Extend-a-panel™. Also push and hold

for a minimum of 3 seconds to reset maintenance

reminders and security features.

E - Choke Control — Used when starting a cold

engine.

F - Start Switch — Push and hold in “Start” position

for a maximum of 5 seconds during each start

attempt, until engine starts.

G - Circuit Breakers (AC) — The 120 Volt AC, 20A

GFCI duplex receptacles are provided with “push

to reset” circuit breakers to protect the generator

against electrical overload.

H - Rocker Switch Main Circuit Breaker — The

120/240 Volt AC, 30A locking receptacle is

provided with a rocker switch circuit breaker to

protect generator against electrical overload.

J - 120/240 Volt AC, 30 Amp Locking Receptacle

— May be used to supply electrical power for the

operation of 120 and/or 240 Volt AC, 30 Amp,

single phase, 60 Hz electrical, lighting, appliance,

tool and motor loads.

K - Rocker Switch Cordset Circuit Breaker — The

cordset on main panel is provided with a double

pole rocker switch circuit breaker to protect

generator against electrical overload.