SDS

MTD SYNTHETIC 2-CYCLE ENGINE OIL October 8, 2015
Page 4 of 8
local regulations. Dispose of via a licensed waste disposal contractor.
NOTE: If RQ (Reportable Quantity) is exceeded or if spills enter a body of water, report immediately to the USEPA’s National
Response Center at [phone]. Check with your local and state regulators regarding their reporting requirements.
Section 7. Handling and Storage
Precautions for safe handling
Protective measures: Eye protection and face shield should be used if material is used under conditions that
increase the chances of splattering. Put on appropriate personal protective equipment
(see Section 8). Keep out of reach of children.
Advice on general
occupational hygiene: Do not get in eyes, on skin or on clothing. Eating, drinking and smoking should be
prohibited in areas where this material is handled, stored and processed. Wash
thoroughly after handling. Remove contaminated clothing and protective equipment
before entering eating areas.
See also Section 8 for additional information on hygiene measures.
Conditions for safe storage,
Including any incompatibilities: Store in accordance with local regulations. Store in original container protected from
direct sunlight in a dry, cool and well-ventilated area, away from incompatible materials,
strong oxidizing agents (see Section 10) and food and drink. Keep away from heat,
sparks, flame and other sources of ignition (i.e., pilot lights, electric motors and static
electricity). Keep container tightly closed and sealed until ready for use. Containers that
have been opened must be carefully resealed and kept upright to prevent leakage. Use
appropriate containment to avoid environmental contamination. Avoid contaminating
soil or releases into sewage or drainage systems and bodies of water.
Bulk material handling: Static Hazard: Electrostatic charge may accumulate and create a hazardous condition
when handling this material. To minimize this hazard, bonding and grounding may be
necessary but may not, by themselves, be sufficient.
Section 8. Exposure Controls/Personal Protection
Control parameters
Occupational Exposure Limits
Chemical name
ACGIH
OSHA
NIOSH
TLV
STEL
PEL
STEL
TWA
Ceiling
Lubricant Base Oil (Petroleum)
Highly refined mineral oils (C15-C50)
5 mg/m3
(mist)
10 mg/m3
(mist)
5 mg/m3
(mist)
_
_
_
Distillates (Petroleum), Hydrotreated, light
(Naphtha) 64742-47-8
200 mg/m3
(non-aerosol)
_
_
_
_
_
Appropriate engineering controls: Good general ventilation should be sufficient to control worker exposure to airborne
contaminants. Emergency shower and eyewash station.
Environmental exposure controls: Emissions from ventilation or work process equipment should be checked to ensure
they comply with the requirements of environmental protection legislation. In some
cases, fume scrubbers, filters or engineering modifications to the process
equipment will be necessary to reduce emissions to acceptable levels.
Individual protection measures
Hygiene measures: Wash hands, forearms and face thoroughly after handling chemical products,
before eating, smoking and using the lavatory and at the end of the working
period. Appropriate techniques should be used to remove potentially
contaminated clothing. Wash contaminated clothing before reusing. Ensure that
eyewash stations and safety showers are close to the workstation location.
Eye/Face Protection: Wear safety glasses with side shields. A face shield may be necessary under
some conditions.
Skin and Body Protection