Full Product Manual

Fig. 22

Bump Knob

Fig. 24

Cutting

Head Base

Inner Reel

Spool Cover

Tab

Tab Slot

Removing Old Trimming Line and Obstructions (Bump Head)

1. When the trimming line runs out, the last piece should

automatically eject from the cutting head. If it does not, pull the

remaining line out of the cutting head.

2. If the line will not come out or the cutting head is otherwise

obstructed:

a. Insert a flat-head screwdriver into the notch on the tab (Fig. 23).

b.Gently tilt the screwdriver up and ho

ld it in place (Fig. 23).

. While holding the screwdriver in place, gently twist the

screwdriver to unlock the tab from the tab slot (Fig. 24).

d.Remove the spool cover (Fig. 24). DO NOT remove the spring

from the cutting head base (Fig. 24).

e. Push the bump knob through the spool cover. (Fig. 24). If the

eyelets come off, reinsert the eyelets on the spool cover (Fig. 21).

NOTE: DO NOT separate the bump kno

b from the inner reel (Fig. 24).

. Remove any old trimming line and/or obstructions.

g. Use a clean cloth to clean the inner reel, cutting head base

and spool cover (Fig. 24).

h. Insert the bump knob and inner reel into the spool cover (Fig. 24).

i. Align the tabs on the spool cover with the tab slots on the

cutting head base (Fig. 24). Push the spool cover onto the

cutting head base until the tabs secure

ly snap into place.

Bump Knob

Spring

Fig. 23

Tab

Notch