Full Product Manual

ManualsBrandsTroy-Bilt ManualsGas String Trimmers30 cc 4-Cycle Straight Shaft Attachment Capable Gas Trimmer with JumpStart Capabilities

USING THE ELECTRIC START ACCESSORY

Fig. 14

Electric Start

Port

STARTING INSTRUCTIONS

NOTE: To prevent the throttle control from being squeezed

accidentally, this unit has a throttle lockout. The throttle control

cannot be squeezed unless the throttle lockout is also engaged.

NOTE: There is no need to turn the unit on. The On/Off switch is in

the On ( I ) position at all times (Fig. 11).

Before Starting the Unit

1. Check the oil level. Refer to Checking the Oil Level.

2. F

ill the fuel tank. Refer to Fueling the Unit.

tarting the Unit

Read the Operator's Manual that came with the electric start

accessory before attempting these instructions.

1. Slowly press and release the primer bulb 10 times (Fig. 12).

2. Crouch in the starting position (Fig. 13).

3. Insert the electric start accessory into the electric start port (Fig. 14).

4. Press and hold the throttle lockout (Fig. 11). S

queeze and hold

he throttle control (Fig. 11).

5. Continue to hold the throttle lockout and throttle control. Run

the electric start accessory in intervals no longer than 2 seconds

each until the unit starts.

6. Remove the electric start accessory from the unit, unless specified

otherwise in the electric start accessory Operator's Manual.

IF... the engine does not start, repeat the starting procedure.

IF...

the engine fails to start after 3 attempts: Press and hold the

throttle lockout. Squeeze and hold the throttle control. Run the

electric start accessory in intervals no longer than 2 seconds

each until the unit starts. Remove the electric start accessory

from the unit, unless specified otherwise in the electric start

accessory Operator's Manual.

IF... the engine stops while the throttle control is squeez

ed, re

peat

the starting procedure.

IF THE ENGINE IS HOT... repeat the starting procedure.

STOPPING INSTRUCTIONS

1. Release the throttle control and allow the engine to idle.

2. Press and hold the On/Off switch in the Off (O) position until the

engine comes to a complete stop (Fig. 11).

This unit can be started with an optional electric start accessory

(items sold separately). Refer to the electric start accessory

perator’s manual for the proper use of this feature.

Please contact your local retailer, call the Customer Support

Department or visit our website for more information.